Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 58)

46 12" & 16" Series II Sweep PNEG-720-G2
Assembly
17. CENTER PIVOT INSTALLATION (cont.)
3. Feed the power cord through the pivot tube.
4. Align the hole in the backshield with the pivot tube and push the sweep onto the pivot tube.
5. Connect the pivot plate to the backshield using two (2) 1/2"-13 x 1-3/4" hex bolts, flat washers,
lockwashers, and hex nuts.
6. Fasten the pivot rod to the backshield and pivot plate using two (2) 1/2"-13 x 2" hex bolts,
lockwashers, and hex nuts.
7. Screw the 45 degree grease fitting into the pivot assembly pipe.
pivot plate
pivot tube
pivot assembly
45 degree
grease fitting
multi-conductor
cord
lockwasher
flat washer
pivot rod
hex nut
1/2"-13 x 1 3/4" hex bolt
1/2"-13 x 2" hex bolt
FIG. 17-A3
cord