Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 40)

34 12" & 16" Series II Sweep PNEG-720-G2
Assembly
13. MOTOR INSTALLATION
FIG. 13
Top Plate
Assembly
1" flat
washer
1" hex nut
motor
Line Up
Face of
Shafts
BEFORE
bolting
motor.
A. Level the Top Plate Assembly by adjusting
the 1" nuts and washers on the adjustment
rods. (See Fig 13)
B. Line up the end face of the shafts as closely
as possible before bolting motor to mount-
ing plate. (See Fig 13-A)
C. Fasten the motor to the motor mount using
hex bolts, lockwashers, and hex nuts.
(See Motor Bolt Chart for bolt sizes.)
FIG. 13-A
adjustment rod
motor bolt
(see chart
for size)
Motor Size Hex Bolt Size Qty.
213T 3/8"-16 x 1-1/4" 4
215T 3/8"-16 x 1-1/4" 4
254T 1/2"-13 x 1-3/4" 4
256T 1/2"-13 x 1-3/4" 4
284T 1/2"-13 x 1-3/4" 4
286T 1/2"-13 x 1-3/4" 4
Motor Bolt Chart