Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 46)

12" & 16" Series II Sweep Special PNEG-1579
Assembly
14. SHEAVE INSTALLATION (cont.)
Slide belt guard top
assembly over lower belt
guard assembly
attachment bolts
J. Slide the belt guard top assembly over the lower belt guard assembly attachment bolts. Attach the
belt guard top assembly to the fill plate using 3/8-16 x 1 HHCS, 3/8 flat washers and 3/8 lock wash-
ers. Slide the complete belt guard assembly as close to the motor as possible without allowing the
sheaves or the belt to rub the steel guard. Tighten the belt guard attachment bolts.
FIG. 14J
Attach the top belt assembly
to the belt guard fill plate
assembly with 3/8"-16 x 1"
HHCS, 3/8" flat washers
and 3/8" lock washers
Slide the belt guard as close to
motor as possible without
allowing sheaves or belt to rub
front of guard. Tighten the bolts.
36-B