TC Electronic G-Major 2 - Manual (Page 12)

11
BASIC SETUPS
E
N
G
L
IS
H
Connecting and setting up G-Major 2
Parallel setup using a line mixer
• Connect the output of your preamp to an
input on the line mixer.
• If you want to switch preamp channels with
G-Major 2, connect the SWITCH OUT jack
on G-Major 2 to the channel switching jacks
on your preamp. This is not required for
MIDI-controllable preamps.
• Connect the send jacks of your line mixer’s
effect loop to the inputs of G-Major 2.
Connect the outputs of G-Major 2 to the
return jacks of your line mixer’s effect loop.
• Connect the line mixer’s main outputs to
your amplification system.
This illustration shows combo amplifiers – but
of course, you could also use a power amp
here. Likewise, the preamp shown in the
illustration could easily be the preamp section
of a combo amplifier.
Combined setup with regular effect
pedals, a G-Major 2 and a MIDI pedal
• Connect the send jack of the combo’s effect
loop to the input of G-Major 2.
• Connect the output of G-Major 2 to the
return jack of the combo’s effect loop.
• Connect your guitar to the input of your
(first) effect pedal. Connect the output of the
(last) effect pedal to the input of the combo
as usual.
• If you wish to switch presets on G-Major 2
(which may include switching the channels
of your preamp/combo), you should also
connect a MIDI pedal to G-Major 2 and use
the Relay Switching function.