TC Electronic G-Major 2 - Manual (Page 34)

33
Touch Res Filter
– Additional Parameters
The Touch Resonance filter creates an effect
similar to a Touch Wah. The sweep through a
frequency range is controlled via the dynamics
of the input signal.
Sense – Sensitivity
Range: 0 to 10
The sensitivity should be set according to the
Input level on the Filter block. The lower the
setting, the harder the effect section should be
hit to create the “whack” effect.
Response
Settings: Slow/Fast
This parameter sets the response time, i.e. how
fast the “quack” should occur when you hit the
strings.
Fmax – Frequency Max
Range: 1 to 10 kHz
This parameter can limit range of the sweep.
Most likely you will find a full range sounding
too harsh and bright.
You will probably find settings between 2 kHz
and 4 kHz to give excellent results.
Tremolo
Introduction
A Tremolo is basically a change of the signal
level controlled by an LFO. G-Major 2 offers
several variations of this effect; ranging from
soft and smooth to hard and aggressive.
Speed
Range: 0.050 Hz to 20 Hz
This parameter sets the speed of the effect.
Tempo
Range: Ignore, 1 to 1/32T (T= Triplet & D=
Dotted)
When set to any value between 2 and 1/32T,
the Global Tempo is subdivided according to
this setting. When set to “Ignore”, the speed set
using the Speed parameter is used instead.
The Tap Master parameter – located in
the Global menu – specifies whether
the Global tempo or the tempo set by
the Speed parameter in each preset
should be used at preset change.
Depth
Range: 0 to 100 %
This parameter sets the intensity of the effect. A
100 % setting means that the signal is
completely muted between signal peaks.
Type
Settings: Soft/Hard (Sinus or Square)
Two waveforms are available as modulation
sources for the Tremolo effect. Setting this
parameter to “Hard” results in a steeper,
recognizable effect. Listen and choose the
appropriate option.
Sine
Square
PulseWidth
Range: 0 to 100 %
If you set this parameter e.g. to 20 % with the
Type parameter set to Hard, the signal will be
heard in one channel for 20 % of the time and
in the other one for 80 % of the time. With a
Type setting of Soft, a 50 % setting would yield
FILTER
E
N
G
L
IS
H