TC Electronic G-Major 2 - Manual (Page 49)

48
Dynamic Delay
The Dynamic Delay is a feature that was
initially introduced in the well-recognized TC
2290. It allows the dynamics of the Input level
to actively alter the Delay Output level, which
leaves the source signal clear and undisturbed
while you play. The Dynamic Delay delicately
complements your performance.
Use the Sense parameter to determine when
the delays should “re-surface”. Use the Offset
parameter to widen the stereo image.
In addition to the “common” parameters
described in the introduction of the delay
section, this delay has the following
parameters:
Offset
Range: 0 to 200
This parameter offsets the Delay repeats in the
right channel only. For a “wide” stereo effect,
the delay in the two channels should not occur
at exactly the same time. For a “wide” effect, a
few milliseconds should do the trick. Using
more than that will give you anything from a
generous slap-back effect on the repeats to
more extreme effects.
Sense – Sensitivity
Range: -50 to 0 dB
The sensitivity parameter determines how soon
the delay repeats should become audible in
relation to the Input signal level. This parameter
acts a threshold between your guitar signal and
the delay repeats.
Damp
Range: 0 to 100 dB
As explained in the introduction, the Dynamic
Delay attenuates the delay repeats level based
on the current level of the input signal. The
Damp parameter sets the amount of
attenuation.
Rel – Release
Range: 20 to 1000 ms
This parameter determines how fast the
attenuation of the delay repeats is released.
Dual Delay
This true Dual Delay lets you set two
independent delay taps, each with its own
Tempo parameter, High and Low cut filter, as
well as a “Pan” knob.
In addition to the “common” parameters
described in the introduction of the delay
section, this delay has the following
parameters:
Pan1 & Pan2
Range: 50L to 50R
Defines the panning position of the delay
repeats for delay lines 1 and 2.
Reverse
The Reverse delay is a great effect when a
more mysterious, exotic delay style is required.
Use the Feedback High-Cut parameter to soften
the delay.
All common parameters
Please refer to the section “Delay –
Introduction” for a description of this Delay’s
parameters.
The range of the Delay time for this delay type
is 50 ms to 800 ms.
DELAY