SOLO 433 Hochdruckspritze - Manual (Page 27)

Assembly ; Adjusting the carrying straps ; Fuelling
ENGLISH 9
6. Assembly
The high pressure sprayer may only be used after
complete assembly and after the carrying straps
have been adjusted correctly!
To facilitate packing and transport, the spray wand
(17) and trigger handle (15) are not attached to the
pressure hose (14)
Fasten the pressure hose (14) to the trigger
handle (15) by tightening the hex. Nut (20)
7. Adjusting the carrying straps
Use the sliding clips, adjust the shoulder straps to
the right length.
a) Pull the loose ends of the carrying straps to
tighten them.
b) Lift up the two sliding clips again to release the
straps.
When adjusting the straps, ensure that the back
panel fits snugly and securely against the back of
the person wearing the backpack.
8. Fuelling
Always comply carefully with the specifications
in the separate operating instructions for the
engine.
8.1 Model with a Honda 4-stroke engine
Unleaded normal petrol can be used as fuel.
Before starting up the tool, always check that there
is enough suitable engine oil in the oil tank (the
dipstick is located in the oil tank cap – for further
information refer to the operating instructions for
the engine).
We recommend
SOLO All year 4-stroke engine oil, part no.:
0083115.
8.2 Fuelling
While fuelling always follow all safety instructions
and take all safety precautions.
Handle fuel only with the engine turned off.
Carefully clean the area around the filler inlet.
Place the machine with the fuel inlet pointing
upwards. Unscrew the tank lid and fill the fuel
mixture up to the lower edge of the filler neck. Use
a funnel with filter to prevent tank contamination.
After filling the tank replace the tank lid and tighten
firmly.
Fig. 3
Fig. 4