Net Optics iBypass 40G - Manual (Page 8)

8
Step 2
Connect Power
Ensure the iBypass 40G Switch is grounded before connecting power. Do the
following to connect and apply power to the iBypass 40G Switch:
1. Plug one of the supplied power cords to a power connector located at the rear
of the chassis. Plug the other end to a power source. See Figure 4.
2. For redundancy, plug the other power cord to the iBypass 40G. Plug the other
end to a source independent from the first power source.
The Power LEDs on the front illuminate.
Switch Default Settings
The iBypass 40G Switch ships with the following default system settings:
Management Port IP: 10.60.4.180 Threshold Ports A & 1: 80%
Management Port Netmask: 255.0.0.0 Threshold Port B & 2: 80%
Management Port Gateway: 10.0.0.1 Username: admin
Port Speed (A, B, 1, and 2): 40G Password: netoptics