Asus PIKE 1078 - Manual (Page 18)

2-4 Chapter 2: RAID configuration
2.2 LSI WebBIOS Configuration Utility
The LSI WebBIOS Configuration Utility (CU) is an integrated RAID solution that
allows you to create RAID 0, 1, 10, 5, 50, 6, and 60 set(s) from SAS hard disk
drives supported by the LSI SAS 1078 controller.
You can also use the WebBIOS CU to do the following tasks:
•
Create physical arrays and virtual disks for storage configurations
• Delete virtual disks
• Migrate a storage configuration to a different RAID level
• Detect configuration mismatches
• Import a foreign configuration
• Display adapter, virtual disk, and physical drive properties.
• Scan devices connected to the controller
• Initialize virtual disks
• Check configurations for data consistency
• PIKE 1078 does not support the Battery Backup Unit (BBU) function.
• You may use disks of different sizes; however, the size of the smallest disk
determines the “logical” size of each member disk.
• DO NOT combine Serial ATA and SAS disk drives in one volume.
• The RAID setup screens shown in this section are for reference only and
may not exactly match the items on your screen due to the controller
version difference.
LSI MegaRAID SAS-MFI BIOS
Version NT16 (Build Nov 20, 2007)
Copyright(C) 2007 LSI Corporation
HA -0 (Bus 2 Dev 0) MegaRAID SAS PCI Express(TM) ROMB
FW package: 8.0.1-0029
Battery Status: Not present
SLOT ID LUN VENDOR PRODUCT REVISION CAPACITY
---- -- --- ------ ------- -------- --------
6 LSI MegaRAID SAS PCI Express(1.12.122-0393256MB
6 0 0 ATA Hitachi HDS72161 AB3A 157066MB
6 2 0 ATA Hitachi HDS72161 AB3A 157066MB
6 3 0 ATA Hitachi HDS72161 AB3A 157066MB
6 4 0 ATA Hitachi HDS72107 A70M 715404MB
6 5 0 ATA Hitachi HDS72107 A70M 715404MB
6 6 0 ATA Hitachi HDS72107 A70M 715404MB
0 Virtual Drive(s) found on the host adapter.
0 Virtual Drive(s) handled by BIOS
Press <Ctrl><H> for WebBIOS or press <Ctrl><Y> for Preboot CLI
2.2.1 Starting the WebBIOS CU
Follow these steps to start the WebBIOS CU and access the main screen.
1. Turn on the system after installing all SAS hard disk drives.
2. During POST, press <Ctrl+H> when the following text appears on the screen:
The Adapter Selection screen appears.
Press <Ctrl+Y> for Preboot CLI: this option is for advanced debug only!