Asus ESC500 G3 - Manual (Page 122)

4-44 Chapter 4: BIOS setup
Network Stack Driver Support [Disabled]
[Disabled] Select to skip the network stack driver from loading during POST.
[Enabled] Select to load the network stack driver during POST.
Next Boot after AC Power Loss [Normal Boot]
[Normal Boot] Returns to normal boot on the next boot after an AC power loss.
[Fast Boot]
Accelerates the boot speed on the next boot after an AC power loss.
HW Fast Boot [Disabled]
Allows the system to enable or disable the HW Fast Boot.
Configuration options: [Disabled] [Enabled]
DirectKey Enable [Go to BIOS...]
[Disabled] Disables the DirectKey button. The system will only power on or off
when you press the DirectKey button.
[Go to BIOS
Setup]
Allows the system to power on and go to the BIOS Setup directly when
you press the DirectKey button.
PS/2 Keyboard and Mouse Support [Auto]
Select any of these settings when PS/2 keyboard and mouse are installed. These
settings only apply when Fast Boot is enabled.
[Auto] For a faster POST time, PS/2 devices will only be
available when the system boots up or rebooted when the
PS/2 devices have not been reconnected or changed. If
you disconnect or change PS/2 devices before restarting
the system, PS/2 devices will not be available and BIOS
setup program will not be accessible via PS/2 devices.
[Full Initialization] For full system control, PS/2 devices will be available
during POST at any circumstances. This process will
extend POST time.
[Disabled] For the fastest POST time, all PS/2 devices will not be
available until your computer enters the operating system.
Boot Logo Display [Enabled]
[Enabled] Enables the full screen boot logo display during POST.
[Disabled] Disables the full screen boot logo display during POST.
Boot Logo Size Control [Auto]
[Auto]
Automatically adjusts for Windows ® requirements.
[Full Screen] Maximizes the boot logo size.