Asus ESC500 G3 - Manual (Page 38)

Chapter 2: Hardware setup 2-18
2.6.2 Installing 5.25-inch drives into the drive bay
To install 5.25-inch drives:
1. Select the drive bay you intend to
use and remove the drive slot plate
cover.
2. Release the bay locks by pulling
them outwards.
3. Insert the drive into the 5.25-inch
drive bay and carefully push the
drive into the bay until its screw
holes align with the holes on the
bay.
5. Connect a 7-pin SATA cable (from
the motherboard SATA port) and a
15-pin power plug (from the power
supply unit) to the rear connectors
of the hard disk or optical drive.
4. Push in the bay locks to secure the
optical drive