Xylem HVS 1.1 - 3.4 - Manual (Page 23)

23
6 Settings at the Submenu – Programming Device
You are always able to connect the programming device to HYDROVAR SENSORLESS.
The LED will change the colour to orange, when connection was successful.
POWER X.X %
SPEED X.X Hz
The actual Power [%] and the actual output
frequency [Hz] are displayed.
POWER SAVING
X.XX KW
Shows the actually saved energy [kW]
TOTAL SAVINGS
XX.XX EUR
Shows the whole saved energy costs
(in EUR / USD / GBP / CHF)
General for operating with the external programming device:
With Í and Î you can select the different parameters in the menu.
To enter a submenu, press the Ð button. To leave the submenu, you have to press the
buttons Í or Î for longer than 3 sec.
With Ï or Ð you can change the parameters.
Each change in the settings is saved after leaving this parameter with the buttons
Í
or Î.
When you have changed a parameter and you leave it, the LCD shows you the following
message
SAVE
PARAMETER
for about 2 sec.
SUBMENU
PARAMETER
From the 1 st display, press the Î button to reach
PASSWORD
0000
Then press the Ð button and the display will change to
NOTICE!
The Password protection prevents untrained personnel from accidentally changing the
base settings
PASSWORD
0066
Press the Ï button until you reach the number 0066
Hold the Î button down to reach the next display