YSI 3200 - Manual (Page 24)

System Configuration and Operation Section 3
684
mg/L
TDS
0.4
ppt
SAL 1.91%/°C
T CELL
ENTER TO CHANGE UNITS
SIZE NEXT LIGHT DARK
MEASUREMENT UNITS
Each of the six fields on the small display (three fields on the large display) may be setup by the
user. Selection of fields is important, even if only the large display is used, because, when a
reading is stored in the 3200 memory, the date, time, temperature and conductivity are stored,
along with the first two additional fields (fields other than date, time, temperature and
conductivity) currently on the display. These same selected fields are also used when logging data
to a computer or serial printer.
1006
uS/cm
9999uS SETUP DISP
65.68
°F
97.8 Ω
K=0.098
25.0°C
684
mg/L
TDS
0.4
ppt
SAL 1.91%/°C
T CELL
ENTER TO CHANGE UNITS
SIZE NEXT LIGHT DARK
From the Setup Disp screen, press the [NEXT] soft key to select the field you want to change,
then press [ENTER] repeatedly to change the field until the information you want is displayed.
Each field may contain one of the following:
•
Conductance, S, mS, uS
•
Conductivity, S/cm, mS/cm, uS/cm
•
Resistance,
Ω (ohms), KΩ, MΩ
•
Resistivity,
Ω-cm, KΩ-cm, MΩ-cm
•
Total Dissolved Solids, mg/L
•
Salinity, ppt
•
Time
•
Date
•
Temperature, °C
•
Temperature, °F
•
Blank
YSI Incorporated Model 3200 20