YSI 5000 - Manual (Page 46)

43
1. Prepare the scanner by installing the ferrite bead on the scanner’s cable near to where it plugs
into the 5100 meter as shown in the following diagram:
2. Turn to page 1-7 and scan the “Keyboard Wedge Interface for IBM PC AT and compatibles”
bar code label. The scanner should beep, indicating that it is ready to be used.
3. Test the bar code reader configuration by selecting Remote mode from the Application menu
of the 5100 and scanning a BOD bottle label. The bar code reader and 5100 meter will beep
and the 5100 will briefly display ”BC” along with the bar code number.
B) Laser Wedge 300 scanner
The following instructions involve the Laser Wedge 300 Bar Code Reader Programming Menus
booklet:
1. Turn to the page entitled “Bar Codes For Menus”, the last page in the booklet. Fold out the
page so that the list of bar codes is scanable. Keep this page unfolded for later use as it
contains the numbers and letters that will be used to program the bar code reader in the
following steps.
2. Turn to the page entitled “Status Check”, the second to last page. Scan the DEFAULT ALL
PARAMETERS bar code to load the factory default parameters. The bar code reader will
beep to indicate a successful scan.