YSI 6500 Environmental Process Monitor - Manual (Page 27)

System Setup Section 3
In the above example, the temperature parameter has been selected. The user can select a
displayed unit using the
↑↓ arrows to highlight. If the user selects NONE, the temperature
parameter will not appear in the report. When the desired selection has been made, press enter to
activate the change. In this example, temperature in degrees Celsius has been designated for
display and will appear on the display when the 6500 Monitor is in the Run mode. The main
report menu will then reappear and reflect the change just made. Although not shown, unit
changes to other parameters (conductivity, specific conductance, resistivity, TDS, depth, volume)
can be made by using the arrow keys to scroll downward to display these selections and the Enter
key to activate the Select Units menu. The appropriate unit selections can then be made.
After you have chosen the appropriate sensors and report parameters associated with your 6-
Series Sonde, it is now configured properly for display of the desired parameters in the Run mode
of the 6500 Monitor. To assure that everything is correct, press Esc until the Run display (similar
to that shown below) appears on the 6500 screen.
If you are connecting multiple sondes to your 6500 Monitor, please see section 3.3.6 for
instruction on multiple sonde configuration.
3.3 6500 MONITOR SETUP
After proper setup of your 6-Series Sonde, you must configure the options offered with the 6500
Monitor. It is not required that the sonde be attached to the monitor to implement this setup
procedure.
With ac line power applied to the 6500 Monitor, press the Esc and Enter keys simultaneously for
1 second to display the Main 6500 menu on the monitor display.
YSI Incorporated 6500 Environmental Process Monitor 23