YSI 6500 Environmental Process Monitor - Manual (Page 38)

System Setup Section 3
To change an SDI-12 addresses, highlight the current SDI-12 address of the sonde you wish to
change and press Enter to select it. A new screen showing available new addresses will be
displayed.
Choose the desired address and press Enter to select it. The 6500 Monitor will then display a
confirmation choice verify that your selection was correct.
The current active choice will flash. Verify your choice is correct and use the arrow keys to
highlight “yes” or “no”. Then press Enter when you have made your choice. If “yes” is selected,
the 6500 Monitor will update your sonde’s SDI-12 address and return to the main menu. If “no”
is selected, the 6500 Monitor will return to the main menu, but will not update your sonde’s SDI-
12 address.
3.3.7
SYSTEM STATUS
This item allows the user to determine the current version of the 6500 Monitor software and is
also intended for future feature enhancements for the 6500.
Highlight the System status selection and press Enter to produce the following display.
YSI Incorporated 6500 Environmental Process Monitor 34