YSI DIQ/S 182-MOD System 182 - Manual (Page 44)

Installation System 182
3 - 30 ba76025e01 02/2012
Preparing the power
cable
Fig. 3-25 Prepared power cable.
Caution
The ground wire must not project into the enclosure. Otherwise,
malfunctions could occur.
1 Cut off the cable to the required length.
2 Strip the cable insulation for approx. 45 mm.
3 Bare the wires of phases L and N and fit them with wire end
sleeves.
4 If present, cut off the ground wire at the end of the cable
sheath.
approx. 45 mm
L
N
cut ground wire here