Xylem MULTI 3400i pH/Cond MULTI-PARAMETER METERS - Manual (Page 48)

Operation pH/Cond 3400i
48
As soon as all of the 500 storage locations are occupied, AutoStore is
terminated (Int 1 = OFF). If there are not enough storage locations
available for your measurements:
z Output and backup the data storage (see page 49) and
z Clear the memory (see page 54).
Note
The AutoStore function is interrupted if you start other functions, e.g.
output the data storage. After the function is finished, the AutoStore
function is continued. By this, however, temporal gaps in the recording
of the measured values will occur.
Switching off AutoStore Switch AutoStore off by:
z setting the save interval (Int 1) to OFF, or
z switching the measuring instrument off and then on again.
6 Set the required ID number with <
▲> <▼>.
7 Confirm with <RUN/ENTER>.
The measuring instrument switches to the last active measur-
ing mode and starts the measuring and saving procedure. Au-
toStore flashes on the display.
e r F
9 9 9
S
1
LoBat
Tref25
nLF
/ K %
RCL
Sal
°
AR
TP
C
M
m
% mg/l
cm
S/ cm
cm 1/
° F
ARng Cal Lin
Tref20
Sal TDS
mbar
O UpH
mV/pH
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Year
1
Store Auto
Ident