Xylem MULTI 3400i pH/Cond MULTI-PARAMETER METERS - Manual (Page 62)

Operation pH/Cond 3400i
62
4.9 Reset
You can reset (initialize) the measurement parameters and the config-
uration parameters separately from one another.
Measurement
parameters
The following measuring parameters are reset to the delivery status:
pH
Cond
Note
The calibration data gets lost when the measuring parameters are re-
set. Recalibrate after performing a reset.
Configuration
parameters
The following configuration parameters (InI) are reset to the delivery
status:
Measuring mode pH
Slope -59.16 mV/pH
Asymmetry 0 mV
Manual temperature input 25 °C
Measuring mode
Cell constant 0.475 cm
-1
(calibrated)
0.475 cm
-1
(set up)
Temperature compensation nLF
Reference temperature
Temperature coefficient of the lin-
ear temperature compensation 2.000 %/K
Baud rate 4800
Display during the
pH calibration Buffer nominal value
Interval 1
(automatic save)
OFF
Interval 2
(for data transmission)
OFF