Extron Electronics IN1508 User Guide - Manual (Page 22)

Color/Tint control button — The Color/Tint button selects and deselects the display
color and tint adjustment status indicator bars. The adjustment range for both color and
tint is from 0 to 128.
NOTE: The Color/Tint control affects
only certain interlaced
component video, composite
video, and S-video, as shown in
the table at right.
Input type Color Tint
RGB No No
YUVp No No
RGBcvS No No
YUVi Yes No
NTSC S-video Yes Yes
PAL S-video Yes No
Composite NTSC Yes Yes
Composite PAL Yes No
Input type Color Tint
RGB No No
YUVp No No
RGBcvS No No
YUVi Yes No
NTSC S-video Yes Yes
PAL S-video Yes No
Composite NTSC Yes Yes
Composite PAL Yes No
Zoom button — The Zoom button selects and deselects the Zoom status indicator
bar. Use the and buttons to increase or decrease how much zoom (enlargement) is
applied to the image.
Pan button — The Pan button selects and deselects the horizontal and vertical Pan
status indicator bars. Use the and buttons to highlight the horizontal (H) or vertical
(V) pan status indicator bar. Use the and buttons to pan left and right or up and
down.
NOTE: Pan is available only for an image that has been zoomed in.
Aspect Ratio button — The Aspect Ratio button selects and deselects the aspect ratio
setting selection box control. The aspect ratio options are 4:3 and 16:9. The default is
4:3.
Sharp button — The Sharp button selects and deselects the sharpness setting
adjustment status indicator bar. Sharpness uses variable filtering to affect input picture
detail and definition.
Phase button — The Phase button selects and deselects the phase setting adjustment
status indicator bar. The phase adjustment range is 0 to 31.
NOTE: Phase is not available for DVI, YUVi, S-video, and composite video inputs.
Operations
The following paragraphs detail the power-up process and then describe the menu system,
the picture, and the selection of the front panel security lockout.
Power
Power is applied when the power cord is connected to an AC source. When AC power is
applied, the switcher performs a self-test that cycles all of the front panel LEDs on and off
from left to right. An error-free power up self-test sequence leaves the selected input LED
and the selected Output Rate LED on. If the picture-in-picture feature was turned on when
the switcher was powered down, the PIP On LED and a secondary input LED are also lit.
The selected input, the picture adjustments, and other current settings are saved in non-
volatile memory. When power is applied, the latest configuration is retrieved.
IN1508 • Operation 17