Extron Electronics IN1508 User Guide - Manual (Page 39)

Picture Adjustments
The Picture Control buttons on the front panel and on the IR remote control provide
shortcuts to the fine tuning adjustments for the selected input. All of these adjustments
are also available using the main menu system. When you press one of the front panel or
IR remote control picture control buttons, the on-screen display shows the corresponding
image adjustment screen. The individual descriptions in step 2 below identify the menu
navigation required to reach the screen using the main menu system.
Shortcuts for the centering, sizing, brightness, contrast, color, and tint adjustments are
available from the front panel and the IR remote control (see
figure 27 on page 35).
Shortcuts for the zoom, pan, aspect ratio, sharpness, and pixel phase shift are available from
the IR remote control only (see
figure 28 on page 36).
NOTE: Color and Tint adjustments are available only for interlaced component video,
S-video, and composite video inputs.
1. Press the appropriate picture adjustment button: centering (Center), sizing (Size),
brightness and contrast (Brt/Cont), color and tint (Col/Tnt), sharpness filter (Sharp), fine
pixel phase shift (Phase), or aspect ratio (Aspect). The on-screen display shows the name
of the adjustment and the current setting value.
2. For multiple status bar indicators, use the and buttons to highlight the desired
status bar indicator. Use the and buttons to move the slider on the highlighted
status indicator bar (change the value) for the following adjustments:
• Center: Press the Center button once to toggle between the Window Centering
display and the Image Centering display.
NOTE: The Image Centering display is never shown if the PIP mode is on.
Image Centering display — This display consists of the Horizontal Start and
Vertical Start status indicator bars, which are advanced adjustments that should be
attempted only by knowledgeable A/V professionals (see “
Horizontal Start and
Vertical Start status indicator bars ” on page 42).
Window Centering display — This display consists of two status indicator bars
that show, and allow you to adjust, either the position (centering) of the main
image or the position of the PIP window, depending on whether the PIP feature is
off or on.
PIP is off — Center adjusts the horizontal and vertical position of the main image
on the monitor.
The adjustment range depends on the input rate applied and the output
resolution selected.
This adjustment is also available by using the front panel or IR remote control
to select Menu > Input > Center in the main menu system (see “
Center
selection ” on page 24).
PIP is on — Center adjusts the position of the PIP window.
IN1508 • Operation 34