Extron Electronics IN1508 User Guide - Manual (Page 26)

Menu button — Press the front panel or IR remote control Menu button to activate the
menu system or to back up one level from the currently selected submenu or selection. (For
example, pressing the Menu button in the Picture submenu turns off the Picture submenu
selections and the switcher displays the main menu only).
, , , and buttons — Press the front panel or IR remote control , , , and buttons
to navigate through the menu system, highlighting submenus or selections or increasing and
decreasing selected picture control settings.
Enter button — Press the front panel or IR remote control Enter button to:
• Activate a highlighted submenu or function in the IN1508 main menu system
• Exit a slider-type status indicator bar control
• Save a changed value in a selection box control
NOTE: To return to normal operation (no menus), let the switcher remain idle for 20
seconds until the selected screen times out, or press the front panel or IR remote
control Menu button repeatedly until the Main Menu is deselected.
Differences between selection boxes and status indicator bars
Most of the menu system selections are made using either on-screen selection box controls
(the top example in figure 18) or “sliding” status indicator bar controls (the bottom example
in figure 18). The two types of controls operate differently.
Press Menu or
to exit the screen.
Contrast Contrast
Brightness Brightness +96
+64
(0 to 128)
(0 to 128)
Timeout
Changes take affect as you
move the slider controls.
Typical status indicator bar control
Typical selection box control
Change does not take affect
until Enter is pressed to
activate the selection.
Return to
higher level
screen.
Timeout
RGBHV
RGsB
Y,B-Y,R-Y
RGBS
Push Menu or Enter
to exit the screen.
No
menu
display
Return to
higher level
screen.
No
menu
display
Figure 18. Selection Box vs. Status Indicator Bar Operation
Selection Box Control
The selection boxes (figure 18) show a list of possible selections. When you first activate
the selection box control, the selected option is marked with a . Use the front panel or IR
remote control and buttons to move the to highlight other options.
NOTE: Highlighting a different option by moving the does not automatically select
that option. You must press the front panel or IR remote control Enter button to
change the selection.
Press the front panel or IR remote control Enter button to make changes. The selection box
remains displayed until the on-screen timeout expires or until you exit the screen by pressing
the Menu or button.
IN1508 • Operation 21