Extron Electronics IN1408 - Manual (Page 19)

17
IN1408 Operation Manual - V1.4 3/21/02 12:32 PM © 2002 - INLINE, Inc.
INPUT MENU
Key Concept
To access the input menu via the front panel control buttons, press the desired INPUT SELECT
Button, press MENU, press the
¿ or ¾ button (if necessary) to reach the input menu, then press
ENTER. Use the
¾ and ¿ buttons and the ENTER key to select the setting you wish to adjust.
Once you’ve optimized the setting for the current input, press ENTER to save.
Signal Format: Use this control to select the signal format for each input. Inputs 1 - 8 can accept
either composite or S-Video signals. Inputs 5 - 8 also accept component, progressive component,
RGBHV, RGBS, RGsB or RGB Passive. Inputs 5&6 are the only inputs to accept DVI / TMDS
digital video signals. On Inputs 1 - 4, the composite and S-Video connections are internally wired
together; therefore, either composite or S-Video can be connected to each input, but not both at the
same time. Refer to the Installation Section on page 7 for the specific connections for each signal
format.
Signal Formats available are:
•
Composite
•
S-Video
•
Component Interlaced
(Sub-menu selects NTSC / PAL / SECAM format)
•
Component Progressive
•
RGBS Interlaced
•
RGB Progressive
(Sub-menu selects RGBHV / RGBS / RGsB format)
•
DVI Digital
•
RGB Passive (Passive Switching with No Scaling or Controls Available)
Compatible with RGBHV, RGBS, RGsB, Component Video Progressive or Interlaced
Signals
To configure the inputs for a specific Signal Format:
•
Press the ENTER or MENU Button to access the main menu.
•
Highlight INPUT and press ENTER to access the input menu (use the
¾ and ¿ arrow
buttons to highlight the appropriate menu command).
•
Highlight SIGNAL FORMAT and press ENTER to access the input selection menu.
•
Highlight the input you want to configure and press ENTER to access the signal format
menu.
•
Select the signal format for each individual input (use the
¾ and ¿ buttons to select the
desired signal format).
•
Press ENTER to save the signal format into memory.
Hint: Adjust the IN1408 output settings first. Adjust the resolution, refresh
rate, size, position and sync format, along with the display device settings,
to fit the video image on the screen (use the blue screen if necessary). Once
the IN1408 output settings and the display device settings have been
properly adjusted, the IN408 input settings and video adjustments may be
configured for each input signal.