Extron Electronics IN1408 - Manual (Page 26)

24
© 2002 - INLINE, Inc. IN1408 Operation Manual - V1.4 3/21/02 12:32 PM
User Memory: The User Memories (from 5 to 128) store all video, audio and input parameters.
If a different input signal is applied to the IN1408, the User Memory can be recalled to return the
video, audio and input settings for that particular signal. Select from the following options:
•
Save: This saves all of the video, audio and input parameters for the current input
into the selected memory.
•
Recall: This recalls all of the video, audio and input parameters from the selected
memory into the current input.
•
Reset: This resets all video, audio and input parameters for the selected memory
based on the current input mode.
Á
Note: Some parameters such as Active Area and Blanking are input mode dependent.
Before recalling a user memory that has not been previously saved, it is best to reset that
particular memory so it will be programmed for the current input mode
Baud Rate: Allows RS-232 remote users to select the baud rate that matches their remote
control device system.
Delimiters: Use the on screen menu to select the desired command code delimiters. INLINE scalers
can be set to recognize six sets of leading and end codes when using an RS-232 remote:
parentheses ( ), brackets [ ], braces{ }, slashes \ /, less and greater than < >, and signs !#. If desired,
several INLINE products may be connected together on the same RS-232 serial control line with each
device set for a different delimiter pair. Each unit will only respond to codes sent with the
appropriate delimiters and will ignore all other codes.
Reset RS-232 Settings: Resets all RS-232 settings to factory default.
IR Code Format: This menu item selects the IR code format for the IN1408. This may be used
to select an alternative IR code format for installations where the IN1408 IR codes are conflicting
with other devices in the room. The factory default is code bank A and will work when the
optional CTL120 remote is set to code 001. The alternative code format is code bank B. If the
unit is set to Code Bank B, the CTL120 remote must be programmed to code 028 (see the
CTL120 operation manual for more information).
System Info: This is an informative display that shows a variety of information about the
currently selected input signal and scaler output settings on a single screen. The System Info
display may be useful for troubleshooting or to quickly verify various settings. The following
information is included in the System Info display:
•
Input Source
•
Input Signal Standard and Format
•
Input Horizontal Scan Rate
•
Input Vertical Refresh Rate
•
If Input is Interlaced
•
Output Resolution
•
Output Horizontal Scan Rate
•
Output Vertical Refresh Rate
•
Output Sync Format
•
Program Version Number