Extron Electronics IN1408 User Manual
Page 8
6
© 2002 - INLINE, Inc.
IN1408 Operation Manual - V1.4 3/21/02 12:32 PM
4.)
Connect the IN1408 digital audio output (RCA female) to a compatible digital audio decoder
such as a receiver or digital audio processor. Use a 75 ohm cable to make the connection
between the IN1408 digital audio output and the sound system’s coaxial digital audio input.
5.)
Connect the video / computer video source(s) to the appropriate IN1408 input
connectors. All eight inputs can accept either a composite video signal or an S-Video
signal. Inputs 5 - 8 are universal inputs that also accept interlaced component video,
progressive component video, RGBHV, RGBS, or RGsB video signals. For more details,
see Video Signal Input Connection Guide for Inputs 5 - 8 on page 7.
•
Composite video sources with BNC output connectors can be connected using an
IN7200-1 Series high-resolution single coax cable. Devices with an RCA output
connector can be connected using an IN9101 BNC to RCA adapter cable.
•
S-Video Sources may be connected using an IN9098 4-Pin Mini DIN Male to 2-BNC Male
adapter cable (6’ long).
Key Concept
•
Component video sources and Progressive component video sources may be
connected to Input 5, 6, 7 or 8 using an IN9101 RCA to BNC adapter cable or an
IN7300-3 Series 3-BNC cable. Ensure that the component video signals are connected
to the correct connectors.
•
RGsB / RGBS / RGBHV Video Signals from video and computer video sources can be
connected to Input 5, 6, 7 or 8 by using three, four or five BNC cables or a multi-
conductor RGBHV, RGBS or RGB "snake". The IN7000 / IN7200 / IN7300 Series
cables are well suited for this purpose (see RGB Input / Output Installation Cables on
page 42). While making connections, ensure that the red output is connected to the red
input, green output to the green input, etc.
•
Digital Video
sources can be connected to the DVI ports on Inputs 5 and 6.
Video Signal Connection Guide for Inputs 5 - 8
When making connections to inputs 5, 6, 7 or 8, take care to connect each signal component to
the correct BNC connectors as indicated in the table below:
Signal Type
Red
BNC
Green
BNC
Blue
BNC
H / C
Sync
BNC
V Sync
BNC
Composite Video
C
S-Video
C
Y
Component - Interlaced
R-Y
Y
B-Y
Cr
Y
Cb
Component - Progressive
Pr
Y
Pb
RGsB
R
Gs
B
RGBS
R
G
B
S
RGBHV
R
G
B
H
V
On Inputs 1 through 4, Video input signals must only be connected to
either the composite video or the S-video connector on any one input.
DO NOT connect composite video and S-Video signals simultaneously
on the same input!