Extron Electronics IN1408 - Manual (Page 7)

5
IN1408 Operation Manual - V1.4 3/21/02 12:32 PM © 2002 - INLINE, Inc.
Installation
This section offers step-by-step instructions for installing the IN1408 Video Scaler. An
application diagram showing typical connections is provided on the page 8.
Á
Note
Prior to initiating the installation procedure, ensure that the power switch is in the
off mode on the IN1408 and there is no power supply cord connection to the unit.
1.) Place / install the IN1408 at the desired location. Make sure that the unit is seated on a
flat surface or is securely installed in a standard 19” equipment rack using the MTR102
rack ears (provided). The IN1408 is exactly 2U high without the feet. If other equipment
will be located in the space directly below the scaler, the rubber feet on the bottom of the
unit must be removed before mounting it in the equipment rack.
2.) The IN1408 features a DVI video output, a 5-BNC video output and a 15-Pin HD video
output for easy connections to a variety of display devices:
•
Digital display devices can be connected directly to the IN1408 DVI output. If the
video source features a DFP connector, use the appropriate IN9700 Series cable,
DFP / DVI Patch Cable or DFP / DVI adapter (a complete list of available INLINE
digital video cables and adapters can be found on page 9).
•
Display devices that feature BNC input connectors can be connected directly to the
IN1408 BNC video output using three, four or five BNC cables (for RGsB, RGBS
or RGBHV, respectively) or a multi-conductor RGBHV, RGBS or RGB cable. The
INLINE IN7000 / IN7200 / IN7300 Series cables are well suited for this purpose
(see the RGB Input / Output Installation Cables table on page 42). While making
connections, take care to insure that the red output is connected to the red input,
green output is connected to the green input, etc.
•
Display devices with a 15-pin HD input can be connected directly to the IN1408 15-
Pin HD output port using a standard VGA cable. INLINE’s IN8000 Series flexible
VGA cables offer exceptional performance and are available in a variety of lengths.
Á
Note: Since all three outputs are active simultaneously, the IN1408 can directly drive three
separate display devices.
3.) Connect the IN1408 analog stereo audio output (5-pin captive screw terminal) to the audio
system’s line level input (mixer, amplifier, powered speakers, etc.). The output can be set for
balanced or unbalanced output signal as required by wiring the output appropriately (see
wiring diagram below). The analog audio output connector will accept stranded or solid
cables from 20 - 26 AWG.
)RU %DODQFHG 6WHUHR $XGLR 2XWSXW
5LJKW 
5LJKW *URXQG
/HIW *URXQG
/HIW 
)RU 8QEDODQFHG 6WHUHR $XGLR 2XWSXW
5LJKW *URXQG
/HIW *URXQG
/HIW 
5LJKW 
5LJKW 
/HIW