Extron Electronics IN1408 - Manual (Page 30)

28
© 2002 - INLINE, Inc. IN1408 Operation Manual - V1.4 3/21/02 12:32 PM
DEFAULT POWER-UP BUTTONS
An output mode, output sync format or a factory reset may be selected without the use of the
IN1408 menu. This is particularly useful if the monitor does not display an image or if the image
is scrambled. Simply hold down the front panel button while turning on the IN1408. The front
panel buttons perform the following functions:
INPUT 1: Factory Reset
INPUT 2: Set Output Format to RGBHV--
INPUT 3: Set Output Format to RGBHV++
INPUT 4: Set Output Format to RGBS
BLANK: Set Output Format to RGsB
FREEZE: Enable Front Panel
MENU: 640 x 480 @ 60 Hz
LEFT: 800 x 600 @ 60 Hz
UP: 1024 x 768 @ 60 Hz
DOWN: 1152 x 864 @ 60 Hz
RIGHT: 1280 x 1024 @ 60 Hz
ENTER: Factory Reset
OUTPUT POSITIONING
The output position may be adjusted without entering the main menu sequence. Pressing the
arrow keys selects the output position controls if the menu is not on. Afterwards, press enter to
save the output position, or press menu to exit without saving the setting.
The output position simply moves the image on the monitor. It does not add blank borders or
crop any part of the image. However, the apparent effect of blank borders and a cropped image
may be due to the image being incorrectly positioned on the monitor. The blue screen is available
to adjust the output image on the monitor. It as available at any time, even when the input
settings are incorrectly adjusted or the input signal is missing entirely. Use the blue screen to
adjust the output settings (resolution, refresh rate, size, position and sync format) and to verify the
image on the monitor. The video and input settings have no effect on the blue screen. Once the
output settings have been properly adjusted and verified on the monitor, the blue screen can be
turned off, and the video and input settings may then be adjusted.