Extron Electronics IN1408 - Manual (Page 24)

22
© 2002 - INLINE, Inc. IN1408 Operation Manual - V1.4 3/21/02 12:32 PM
Size: This adjusts the output horizontal and vertical size. It shrinks the size to a percentage of
the output resolution selected. The output size is automatically reset anytime a new input aspect
ratio is selected. This setting is useful to manually reduce the height of the output signal when an
anamorphic input signal is connected. The IN1408 only scales up; therefore, the output size
controls will stop at a certain point where the input and output resolution are equal.
Position: Shifts the output image Up / Down / Left / Right on the display device. Unlike input
blanking, the Position control does not crop the image or add blank borders. The output position
is automatically reset anytime a new input aspect ratio is selected. To quickly access the position
adjustment, simply press one of the front panel
¾ ¿ ¼ ½ buttons at any time when the on-screen
menu is not displayed. This immediately shifts the image in the appropriate direction. Press ENTER
to accept the new setting. If desired, t
he position control can also be accessed using the Position
on-screen menu item under Output menu.
Sync Format: Select an output signal format that is compatible with your display.
RGBHV--
RGB with negative horizontal and vertical sync (default)
RGBHV++ RGB with positive horizontal and vertical sync
RGBS RGB with composite sync (without serrations)
RGBS w/Serr RGB with composite sync (with serrations)
RGsB RGB with sync on green (without serrations)
RGsB w/Serr RGB with sync on green (with serrations)
Blue Screen: Available anytime (even when the input settings are incorrectly adjusted or the
input signal is missing entirely), the blue screen may be used as a test signal to adjust the output
settings (resolution, refresh rate, size, position and sync format) and verify the image on the
monitor. The video and input settings have no effect on the blue screen. Once the output settings
have been properly adjusted and verified on the monitor, the blue screen may be turned off to
adjust the video and input settings.
BNC Output: Use this menu item to select the color space format for the 5-BNC output.
The factory default is RGB color space (RGBHV, RGBS or RGsB). If you are connecting to an
HDTV display or other device that requires a component video signal, set this menu item to
Component. This adjustment does not affect the 15-Pin HD and DVI output, which always
output signals in the RGB color space.
RGB Gain: This is a global setting that can be adjusted to compensate for the color temperature
of the display device. This RGB gain setting only applies to composite video and S-video
signals.
Range: 0 to 255 Factory Default Setting: 128
Operation: Press
½ button to increase the Red, Green or Blue Gain.
Press
¼ button to decrease the Red, Green or Blue Gain.
Reset Output Settings: Resets all output settings to factory default.