Extron Electronics MGP 462xi Series - Manual (Page 143)

B-9 MGP Series • Firmware Update Guide
PRELIMINAR
Y
• TCP/IP tab — Enter your MGP’s IP address (obtained from your system
administrator), Telnet port (the default is 23), and, if required, password.
• RS-232 tab — From the drop-down menus, select the appropriate port
configuration parameters (obtained from your system administrator).
The defaults are shown in the illustration above (9600 baud, no parity,
8 data bits, and one Stop bit).
6 . If you want to upload the firmware to additional device(s),
a
. Click Add Next. Your first device is added to the Devices field in
Firmware Loader window, and the Add Device window remains open.
b . Enter the connection information for the next device.
c . Repeat steps a and b until all desired devices have been added to the
Firmware Loader window.
Firmware Loader window with two MGPs added
To remove a device from the Devices field,
a . Click on the names of the device(s) to be deleted, to highlight them.
b . Select Remove Selected Device(s) from the Edit menu.
c . On the Remove Device(s) window, select or deselect any devices on the
list as desired, then click Remove.
To remove all devices from the Devices field, select Remove All Devices from
the Edit menu.
7 . When finished adding devices, click OK. The Add Device window closes.
8 . From the File menu on the Firmware Loader window, select Open.
9 . In the Choose File window that opens, browse to locate the firmware file to be
uploaded and double-click it to open it. The file extension must be .S19.
C Uploading a file with an incorrect extension may cause the unit to stop
functioning.