Extron Electronics MGP 462xi Series - Manual (Page 33)

3-11 MGP Series • Operation
PRELIMINAR
Y
Input Configuration submenu Horizontal knob adjustment Vertical knob adjustment
Video type
Accepted video signal types include:
RGB S-video
RGBcvS HD-SDI
(MGP 464 HD-SDI only)
YUV-HD Composite video
YUVi DVI (MGP 464 DI and
MGP 464 HD-SDI only)
Select input #1, 2, 3, or 4. Select the desired video format
for the displayed input.
Default: RGB
Film mode
For low resolution inputs. The video
signal type for the input you are
configuring must be set to YUVi,
composite video, or S-video in order
to place the input in film mode.
Select input #1, 2, 3, or 4.
Shows the current film mode
status for the displayed input:
On
, Off, or na (not
applicable).
Select On or Off to turn 3:2 or 2:2
pulldown (film mode) on and off
for the selected input.
Vertical start position
The distance in pixels from the
top edge of the input’s total video
display area to the top edge of its
active area
Select input #1, 2, 3, or 4.
Shows the current vertical
start point for the displayed
input.
Increase or decrease the distance
in pixels from the top edge of
the video display’s total area to
the top edge of its active area.
Default is 128.
Horizontal start position
The distance in pixels from the
left edge of the input’s total video
display area to the left edge of its
active area
Select input #1, 2, 3, or 4.
Shows the current horizontal
start point for the displayed
input.
Increase or decrease the distance
in pixels from the left edge of
the video display’s total area to
the left edge of its active area.
Default is 128.
Pixel phases 1 through 4
The point at which pixels are
sampled for the selected window.
(These values cannot be changed
when the input is DVI, YUVi,
S-video, or composite video.)
Select input #1, 2, 3, or 4 for
the selected window.
Increase or decrease the
displayed value to move the pixel
sampling point for the selected
window to an optimal sampling
point that ensures output clarity.
The range of settings is 0-31;
default is 16.
Total pixels
The width in pixels of the total video
display area. (The values cannot be
changed for DVI, YUVi, S-video, or
composite video inputs.)
Select input #1, 2, 3, or 4. Increase or decrease the width in
pixels of the total video display
area of the selected input. The
default width is marked with an
asterisk (*) on the LCD screen.
Active pixels
The width in pixels of the active
video area
Select input #1, 2, 3, or 4. Increase or decrease the width in
pixels of the active video area of
the selected input. The default
width is marked with an asterisk
(*) on the LCD screen.
Active lines
The height in lines of the active
video area
Select input #1, 2, 3, or 4. Increase or decrease the height in
lines of the active video area of
the selected input. The default
width is marked with an asterisk
(*) on the LCD screen.