Extron Electronics VN-Matrix 300 User Guide - Manual (Page 37)

VN-Matrix 300 • System Configuration 31
Create Display (Decoder)
Select this option to create a Display (Decoder).
z Display will be shown adjacent to a change device type button.
z A display icon will be created in the Configuration window.
Figure 18. Source (Decoder) Configuration and Setup
The Device Setup area provides access the following controls and information.
z Mode:
z
Enable — Normal operation; image transport is enabled.
z
Disable — Image transport is disabled; the local display will show a blank screen.
z
Standby — Same as disable, the display will show a splash screen.
z
Identify — When checked, causes the name of the device to be overlaid on the
decoded image output.
z Source Identify — When checked causes the name of the current source (stream) to be
overlaid on the decoded image output. This value is displayed in brackets immediately
after the device name.
z Data Interface — The selection defines which of the two network interfaces is to be
used for the data transport.
z
Multicast TTL — This value sets the Time To Live (TTL) for multicast packets.
Configuration
z Provides access to the device configuration pages.
z
Select an icon to access the configuration pages.