Extron Electronics VN-QUANTUM User Guide - Manual (Page 12)

Section 1: Installation & Setup VN-QUANTUM User Guide
Page 12 I455GB issue 8
ES3302 & ES3304 Check List
Mains Power Cords
Two IEC 320 (C14) mains power cards are supplied. One is terminated in a 3-pin
‘Edison’ plug (for USA) and the other is unterminated (for Europe and elsewhere).
See page 19 for further details on connecting the mains supply.
Input Card Breakout Cables
These are 26-pin D-type connectors with 12 coaxial flying leads, each approx.
400mm in length and terminated in an inline BNC connector. Check that you have
two cables for each Input Card.
DVI-A to 15-pin VGA Adapters
These adapters are used to connect 15-pin VGA style connectors to the DVI output
connectors. Check that you have two adapters for each Output Card.
Network Crossover Cable
A 5 metre (16ft) crossover patch cable, suitable for direct Ethernet connection
between the VN-QUANTUM Card Frame and the VN-COMMANDER Control PC.
Keyboard and Mouse
A PS/2 compatible QWERTY keyboard and mouse used for low level setup of the
VN-QUANTUM processor.
PS/2 Splitter Cable
A splitter cable for connecting both the keyboard and mouse to the VN-QUANTUM
PS/2 port.
System Disc
A CD-ROM containing VN-QUANTUM software, including VN-COMMANDER, and
User Documentation. Documentation is supplied in Adobe Acrobat (PDF) format.
VN-QUANTUM Card Frame
With Input and Output Cards pre-installed to order.