Extron Electronics VN-QUANTUM User Guide - Manual (Page 44)

Section 2: Hardware Overview VN-QUANTUM User Guide
Page 44 I455GB issue 8
Status Indicators
Lower Access Panel & Latch
A fold-down access panel providing access to the following components:
•
Power On/Off Button
•
System Reset Button
• Flash Drive Bay
•
Power Supply Units
The access panel is normally secured in the closed position by a quarter-turn latch.
Power On/Off Button
A rocker switch used to turn the Card Frame power on and off.
O/S Reset Button
A momentary-action rocker switch used to reset the operating system only. It does not force a
reboot of the Input/Output cards. A full system reboot (e.g. as required after installing new firmware)
will require a power reset (i.e. power off, power on).
Flash Drive
A dual-slot compact flash drive:
Top Slot: Used for Operating System and
Hardware Drivers;
Bottom Slot: Used for System Configuration
Data. This card can also be used to store
local source content (e.g. an image file
containing a background for the target
display).
The drive is normally concealed by a removable
cover that is secured by two thumbscrews.
To remove a card, press the button on the right-
hand side of the card. To insert a card, simply push
the card fully into the slot.
IMPORTANT NOTE: Cards must not be removed
or inserted while the system is operational.
POWER: Lit green when the
mains power supply is OK.
Lit red if one of the PSUs has
failed. DATA: Flashes when data
is being written to, or read
from, the flash drive.