Extron Electronics VN-QUANTUM User Guide - Manual (Page 36)

Section 1: Installation & Setup VN-QUANTUM User Guide
Page 36 I455GB issue 8
Changing Network Settings (using the VN-QUANTUM Control Panel)
Ensure that the VN-QUANTUM is powered down.
Connect a keyboard, mouse and monitor to the VN-QUANTUM Card Frame (see page 33)
Power-up the VN-QUANTUM processor and wait for the VN-QUANTUM logo to appear on the
monitor (this will take up to 90 seconds).
Press the Ctrl and F2 keys simultaneously to display the VN-QUANTUM Control Panel:
Click on Network Settings to display the
following dialog:
In the Network Connection area, choose the
port that you want to change:
o
Control (CONTROL connector)
o
Media 1 (MEDIA I connector)
o
Media 2 (MEDIA II connector)
Change the Network Settings as required
then click Apply or OK.
The new settings will only take effect once the processor has been rebooted.
A message will appear asking you if you want to reboot now.
Click Yes to reboot now or No to reboot later.
Note that the VN-QUANTUM CONNECT processor does not support the use of
the MEDIA I and II ports.
MEDIA II
CONTROL
MEDIA I
MEDIA II
CONTROL
ES3301-2
MEDIA I
ES3302