NXG Technology NX-RM610 - Manual (Page 28)

Erasing the Entire NX-RM610
To erase EVERYTHING, press and hold both the MAIN and the
STOP buttons for 15 seconds. After 15 seconds, the RESET screen
appears. Press the SURE button to erase all of your settings and
return to the factory default setup.
Cloning One NX-RM610 to Another
If you own two or more NX-RM610, you can copy and transfer all
the setup from one NX-RM610 to another. Just follow these easy
steps:
1 Enter SETUP mode by pressing and holding both MAIN and ENT for
three seconds.
Note: You have 30 seconds for each step, otherwise the
NX-RM610 will time out automatically.
2 Press the CLONE button.
3 Align the two NX-RM610 head-to-head, about an inch apart.
4 Press the RECV display button on the new NX-RM610 you would
like to setup by cloning.
5 Press the SEND display button on the NX-RM610 you
previously setup.
6 Press the START button on the new NX-RM610 and then press the
START button on the NX-RM610 you previously setup.
Note: Cloning typically takes about 40 seconds.
After completion, the cloned NX-RM610 will flash “GOOD”.
7 Return to normal operation by pressing the MAIN button twice.
NX-RM610
26
PROG Button
erases three digit
codes, Page, Text
and Punch
Through settings.
ALL Button
erases all
settings.
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 28