NXG Technology NX-RM610 - Manual (Page 33)

3 Press the RF button.
4 The RF Settings Menu appears. See the notes on the following pages
for more info on each option. Make your selection by pressing the
button you want:
5 After you’ve made a new setting and SAVED your change, use the
EXIT button to return to the Setup menu. Use the MAIN button to
return to normal operation.
IR/RF Signal Setting
You can set the signal to be IR line-of-sight only, RF only or IR and
RF simultaneously. Additionally, you can set the signal the same
way for ALL ten of your devices OR you can set the signal
differently for each device (the plasma TV could be set to be IR
line-of-sight only, while the DVD player and the Satellite receiver are
set to be RF only). A good reason to set the signal to RF only is to
prevent too much IR being sent to a sensitive component from two
arrivals at the front panel (one directly from the NX-RM610, one
from the RF base station). A good reason to set the signal to IR
only is that another room has an NX-RF200 base station (no RF
address) so it will receive commands from the NX-RM610 unless
it is set to IR only.
NX-RM610
31
Base Station
ID #
Exit this Menu
RF Button
Signal (IR, RF
or Both)
Emitters - ALL
or a specific
Emitter Blaster - Turn
the Blaster
On or Off
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 33