NXG Technology NX-RM610 - Manual (Page 34)

1 From the RF Settings Menu, select IR/RF.
2 Decide whether you are changing the Signal for all devices or just
one of the devices of the NX-RM610.
Select ALL to change the signal
settings to ALL devices in the
NX-RM610. Then, go to Step 4.
Select DEVIC to change the signal
settings to just one of the devices in
the NX-RM610. Then, go to Step 3.
3 The display changes to a list of the names of your devices. If you
have two pages of devices, pressing either of the page buttons will
display the other page. Select the device you would like to change
IR/RF settings, and then go to Step 4.
4 Select the new setting by pressing the desired button, then press
SAVE to save your new setting and return to the RF settings menu.
NX-RM610
32
Page Button
displays the
other page
of devices.
Select a
device
Change IR from ON to OFF
Change RF from ON to OFF
Save the new setting
Exit this Menu without changing
the IR/RF settings
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 34