Recalling pre-programmed settings – NXG Technology NX-RM610 User Manual
Page 29
Advertising
PAGE
Button
Recalling Pre-Programmed Settings
If you didn’t write down the code numbers you setup your NX-
RM610 with, you can recall them via this simple process:
1
Enter SETUP mode by pressing and holding both MAIN and ENT for
three seconds.
Note: You have 30 seconds for each step, otherwise the NX-
RM610 will time out automatically.
2
Press the RECAL button. The display changes to the first page of the
four recall screens. Press the PAGE button to see the other pages.
3
Write down the code numbers as they appear.
4
Return to normal operation by pressing the MAIN button twice.
NX-RM610
27
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 29
Advertising