NXG Technology NX-RM610 - Manual (Page 37)

Page Button
displays the
other page
of devices.
Select a
device
Displays the
current IR
line output
Save the
new setting
Change the IR
line output
using UP and
DOWN buttons.
Exit this Menu
without changing
the EMITT settings
3 The display changes to a list of the names of your devices. If you
have two pages of devices, pressing either of the page buttons will
display the other page. Select the device you would like to change
the Emitter settings, then go to Step 4.
4 Select the new setting by pressing the desired button, then press
SAVE to save your new setting and return to the RF settings menu.
BLAST - Setting the Front Panel Blaster On or Off
The NX-RF200 Base Stations has a configurable front panel high
power IR LED or “blaster” for controlling components in the same
cabinet space without emitters attached to their front panel. The
front panel blaster can overpower or saturate the sensors of some
A/V components, so if intermittent operation occurs, the blaster
should be turned off.
The blaster is incompatible with a stack of identical components,
since all components will receive IR commands at once, no matter
what device is selected. Turn off the front panel blaster by following
the steps described on the next page:
NX-RM610
35
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 37