Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, 508 & 750) Operators Guide Rev. C - Manual (Page 22)

1 Page 1 - 12 Tank Sentinel Operator’s Guide
Special Keys ( Continued... )
Aborting a Tank or Line
Leak Test
An abort is used to cancel a
test... a test must be aborted
before a different type of leak
test can be started.
The display will show which test
(0.1 or 0.2 GPH) was aborted
once it has been chosen.
After a Tank or Line test is aborted
it is removed from the current-
running, abort-test display as
shown to the left
(in this case,
Tank 2 does not appear because
the test was aborted).
L Y
TEST
0
1) Press the TEST key and then the M3 key (above).
2) Press the UP or DOWN key to show all Leak
Tests that can be aborted (below)
3) Press a menu key under your selection to choose
the Tank or Line test to abort (below)
SELECT LEAK TEST OPTION
STATUS START ABORT
M1 M2 M3 M4
LEFT RIGHT
SELECT TANK TO ABORT
TANK 1
TANK 2 ALL TANKS
M1 M2 M3 M4
LEFT RIGHT
0.2 GPH TANK TEST ABORTED
M1 M2 M3 M4
LEFT RIGHT
SELECT TANK TO ABORT
TANK 1
ALL TANKS
M1 M2 M3 M4
LEFT RIGHT