Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, 508 & 750) Operators Guide Rev. C - Manual (Page 28)

2 Page 2 - 2 Tank Sentinel Operator’s Guide
Visual Alarm Indications
The console has 4 visual output devices:
1) Light green, 80 character display
2) Yellow warning light (Status Row)
3) Red alarm light (Status Row)
4) Printer reports – printout if enabled / programmed
and if the printer has paper
The console display will show a WARNING message under the word SYSTEM when a
system fault occurs. An ALARM message will appear under one of the TANK or SENSOR
or LINE columns when one of those alarms happen.
The status row will indicate System faults by causing the yellow WARNING light to flash
/ turn-on. In addition, the ALARM light will flash when an alarm is detected. (See Status
Row indicators below.)
Visual warnings and alarms act independently from the custom-programmed audio or
printed alarms. The Status Row Indicator lights have 3 different states, they are:
1.) > Flashing < until active, cleared, or transient faults are acknowledged, then
2.) On-steady (solid) once active warnings or alarms are acknowledged, then
3.)Off after all active faults have cleared and have been acknowledged
Depending on how the system was programmed, alarms may, or may not activate the audio
alarm horn when a warning or alarm occurs. Flashing Warning or Alarm lights indicate
that at least one or more new alarms exist since the last time that alarms were
acknowledged. Routinely check the Status Row indicators and printed reports for new
alarms.
POWER
ALARM
TEST
WARNING ALARM
NOTE
☞
NOTE: TANK AND
LINE STATUS COLUMNS
APPEAR ONLY IF THE
NUMBER OF TANKS OR
LINES ARE
PROGRAMMED TO A
VALUE OTHER THAN
ZERO.
➂
Status Row
indicators
SYSTEM TANK SENSOR LINE
WARNING TESTING ALARM OKAY
M1 M2 M3 M4
LEFT RIGHT