Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, 508 & 750) Installation - Manual (Page 78)

SYSTEM WIRING Page 7 - 35 7
After all System Wiring is Complete — Steps
1) Check that all wiring is accurately terminated.
2) Check that each wire is held securely by the terminal hold-down screw (pull
slightly on each wire to check this). If wiring is loose or terminated improperly,
remove the wire, unscrew the terminal hold-down screw (completely) and
re-terminate.
3) Reinstall the metal I.S. cover over the Intrinsically Safe probe / sensor interface
terminals.
4) Reinstall the clear safety shield/covers over the Tank Sentinel AC power/Alarm
Relay/Input terminals.
5) Reinstall the covers over the optional BriteBox ® modules.
WARNING Failure to replace the safety covers and shields will result in a
dangerous situation. An explosion hazard, or an electrical shock hazard will be
created, which may result in property damage, injury, or loss of life.
— ❖ —