Alpha Technologies CE-G Series User Manual
Page 23
3-5
3. Installation
031-093-C0-001 © 3/99
3.3 Installation Procedure, continued
5.
Lay down the vapor barrier material. With a utility knife, make small
cutouts in the material through which the anchor studs protrude.
6.
Place the CE-G enclosure back into place over the mounting studs.
7.
With CE-G enclosure in place and flush against the CE-X enclosure,
install the mounting hardware (flat washers, lock washers, and 3/8
nuts) on each mounting bolt. Do not tighten at this time.
8.
Install the 1 x 1/4 x 20 bolt through the lower left side bolt hole of the
gas utility box cutout (drilled in Step 4). Secure the bolt using a lock
washer, flat washer and nut.
9.
Once the two cabinets have been secured together, evenly tighten the
anchor stud mounting hardware.
NOTE:
ALPHA TECHNOLOGIES is not responsible for
broken welds of other damage to the cabinet
caused by improper installation.