Alpha Technologies CE-G Series - Manual (Page 37)

4. Operation
4-12
031-093-C0-001 © 3/99
2. Install the Low fuel pressure Switch package on to the gas inlet elbow
fitting.
NOTE: The switch package is joined to the input pipe with a
compression fitting. DO NOT overtighten this fitting,
as that will cause it not to be leak tight.
4.5 Pre-Regulator/Low-Fuel Pressure Package Conversion, cont.
LP Gas low fuel pressure switch Installation procedure
1. Route the low fuel pressure switch wires (connector not installed)
located on the back wall of the gas utility box.
Figure 4.19, Low fuel pressure switch placement
Figure 4.18, Low fuel pressure switch wire placement