Alpha Technologies CE-G Series - Manual (Page 27)

4. Operation
4-2
031-093-C0-001 © 3/99
4.2 Installation of Regulator Assembly
1. On tank hold down rod adjust stop nut so that the tank hold down
bracket aligns with the bottom edge of the tank valve guard / handle, as
shown below.
2. Slide regulator / hold down bracket assembly onto the hold down rod.
Ensure regulator assembly is facing same direction of tank valve vapor
ports, and that the hold down bracket’s outermost grooves fits onto the
bottom edge of the valve guard.
Figure 4.3, Stopnut
Figure 4.4, Regulator assembly