Alpha Technologies PWE-SG Series - Manual (Page 13)

NOTE:
Mounting bolts must go completely through the wooden pole and be secured from the back with a large
washer and nut.
Procedure:
Unpack the enclosure and galvanized brackets; turn 1.
the enclosure facedown on a soft surface.
Slide one bracket up through the lower mounting
2.
straps on the rear of the enclosure. The bracket's
flanges face away from the enclosure. Secure the
lower mounting brackets using the 3/8" x 3/4" hex
bolt. See Fig. 2-1.
Mark the position for the upper mounting bracket on
3.
the utility pole. Drill a 3/4" hole completely through
the pole. Secure the bracket with a 5/8" machine bolt,
washer, and nut. Do not fully tighten the bolt at this
time. See Fig. 2-2.
Position the enclosure on the upper mounting
4.
bracket. It may be necessary to slightly rock the
enclosure and pull downward to properly seat it on
the bracket. Center the enclosure on the pole. See
Fig. 2-3.
Mark the hole for the lower mounting brackets. Lift
5.
the enclosure off the top bracket and drill the lower
hole.
Fig. 2-1, Insert bracket
into mounting strap
Fig. 2-2, Secure upper bracket
2.0 Installation, continued
2.1
Wooden Pole Installation, continued
Slide the enclosure back into place over the top bracket. Align the lower bracket with the 6.
hole and secure it with a 5/8" machine bolt, washer, and nut. Both enclosure mounting
straps must rest securely on the brackets. Tighten both brackets until the flanges seat
into the wood. See Fig. 2-3.
The next step is assembling and attaching the conduit to connect the new PWE-SG
7.
enclosure to the legacy enclosure.
Fig. 2-3, Positioning the enclosure on the pole
033-090-C0-001, Rev. A 13