Alpha Technologies PWE-SG Series - Manual (Page 17)

17 033-090-C0-001, Rev. A
If you are not installing optional features, thread the battery cables through the conduit 5.
starting at the end of the conduit which will be attached to the legacy enclosure.
If you are installing a tamper switch or battery heater mat, you must add those wires to
the conduit before you insert the battery cable. It is important to thread the other optional
wires and battery cables through the conduit in the proper order.
First to install a tamper switch, ◊ insert the magnet end of the tamper switch line
into the conduit.
Second to install a battery heater mat
◊ , insert the un-terminated end of the line
cord for the battery heater mat into the conduit.
Next
◊ , insert the end of the battery cables containing the contacts for the
Anderson connectors into the conduit.
Remove the plastic locknut and attach the lower conduit connector (Fig. 2-8) at the 6.
knockout hole. On the inside of the lower enclosure, thread the plastic locknut through
the wiring and using channel locks carefully tighten the plastic locknut, sealing the black
rubber O-ring securely against the enclosure. (Fig. 2-11)
2.0, Installation, continued
2.4 Assembling the Conduit, continued
NOTE:
Always run the lines and battery cables from the top end of the conduit toward the end which will be
connected to the PWE-SG (bottom) enclosure.
Install a conduit connector to the end of the conduit which will be installed in the legacy 4.
(upper) enclosure. Remove the plastic locknut. See Fig. 2-8.
Cut conduit to length a.
Insert conduit through plastic screw ring b.
Insert conduit into connector. Tighten with the plastic screw ring. c.
Before you can proceed to step 5, threading the battery cables and additional d.
wiring through the connector, you must first remove the plastic locknut.
a
b
c
d
Fig.2-8, Conduit Connector