Alpha Technologies PWE-SG Series User Manual
Page 26
033-090-C0-001, Rev.A
26
In the PWE-SG enclosure:
Using a hand rivet gun with 5/32" nosepiece, attach the tamper switch bracket to
1.
the left front flange of the enclosure. See. Fig. 2-23.
Screw the new tamper switch (from the conduit) to the bracket, using the screws
2.
provided.
Attach the magnet to the door of the enclosure using the nuts provided.
3.
2.0
Installation, continued
2.7
Installing Optional Features, continued
2.7.1 Installing the Tamper Switch, continued
2.7.2 Installing the Battery Heater Mat to the PWE-SG Enclosure
Attach tamper switch bracket
Tamper switch magnet
Fig. 2-23, Tamper Switch Installation
Fasten wires to bracket
If necessary, extend battery tray and add the heater mat to the bottom of the tray
1.
or the enclosure.
Replace the battery tray and plug in the line cord to the cord/receptacle from the
2.
conduit kit.
Using tie straps, secure the line cord to the upper left side of the enclosure to
3.
avoid moisture.
NOTE:
You must install the battery heater mat before placing the batteries in the enclosure.
CAUTION!
Take care to attach the battery heater mat line cord to the side of the enclosure with tie straps. It is
important to avoid moisture. See Fig. 2-24.
Line cord secured to
side of enclosure.
Fig.2-24, Attaching Battery Heating Mat Line Cord to Side of Enclosure