Alpha Technologies PWE-SG Series - Manual (Page 16)

033-090-C0-001, Rev.A 16
Procedure:
Locate the knockout in the the upper left corner of the PWE-SG enclosure. Using a 1.
rubber mallet, clear the hole for the conduit.
Drill a similar hole in the legacy enclosure:
2.
Remove the far left battery to provide access a.
Place the hole in the upper left corner of the legacy enclosure, below the equipment b.
tray, and clearing both the tray and any wiring already in place. See Fig. 2-7
Using a 1 3/8" hole saw, drill a hole that will accommodate 1 inch conduit.
c.
Measure the distance between the drilled and knockout holes, adding 6 inches to the
3.
measurement to account for needed flexibility, and cut conduit to size.
2.0 Installation, continued
2.4 Assembling the Conduit
The conduit contains the battery cables and the wiring for other optional features, such as the
tamper switch or battery heater mat. It is used to connect the stand-alone enclosure to the
power supply located in the existing enclosure.
The conduit kit, supplied with the PWE-SG, consists of a sufficient length of weather-sealed
flexible conduit and two connectors.
WARNING!
Before proceeding with the placement and wiring of the batteries and optional
features, turn off the battery breaker and remove all battery connections from
the power supply. Use insulated tools and secure all loose cable ends to
prevent inadvertent unattended connections.
Fig. 2-7, Conduit Placement, Upper Enclosure Interior View
Drill hole to
accommodate
conduit
Hole containing conduit
wiring