American Expedition Vehicles JK HEMI Builder Kit - Installation Guide for 12+ JK Wrangler - Manual (Page 4)

2
7. Remove the battery harness from the TIPM, battery tray, and fender.
8. Disconnect the power steering reservoir from behind the headlamp and discard the mounting bracket.
9. Remove the battery tray from the Jeep. Be sure to remove the bolt on the bottom first (fig 2).
Figure 2
10. Disconnect the ground located on the passenger side of the fire wall (fig 3.)
11. Unplug the 34-way connector located under and behind the passenger side headlamp.
12. Disconnect and remove the ECM (computer).
13. Disconnect AC lines from the compressor.
14. Remove vacuum lines from the brake booster.
15. Separate the vacuum line to vacuum pump next to the AC line (near grill), then remove the fir trees
from the line to separate it from the area next to the radiator (fig 4).
Separate at seam
Figure 3 Figure 4